Please register to participate in our discussions with 2 million other members - it's free and quick! Some forums can only be seen by registered members. After you create your account, you'll be able to customize options and access all our 15,000 new posts/day with fewer ads.
Yes, like others, I'm thinking what I should have in my safe in the near future.
So I am thinking about upper halves but really, I don't know that much about them.
Such as can they be bought without going through an FFL?
Will an upper made by one company fit, work with the lower of another company?
And my biggest problem? Finding them with just the standard carry handle. I'm simple, I don't need rails, think the post is insane, want them with hand guards, post sights and a sling.
Assuming you're talking about the AR-15? Only the lower is an FFL item, all other parts are buy outright. If you go the 80% route even the lower isn't an FFL item. AFAIK all in spec uppers will fit any in spec lower, I'm sure someone will chime in if I'm wrong, not an expert by any means.
Assuming you're talking about the AR-15? Only the lower is an FFL item, all other parts are buy outright. If you go the 80% route even the lower isn't an FFL item. AFAIK all in spec uppers will fit any in spec lower, I'm sure someone will chime in if I'm wrong, not an expert by any means.
Thank you for answering that question.
Anyone on the others? Such as would a Windham upper work on a Rock River lower?
Assuming you're talking about the AR-15? Only the lower is an FFL item, all other parts are buy outright. If you go the 80% route even the lower isn't an FFL item. AFAIK all in spec uppers will fit any in spec lower, I'm sure someone will chime in if I'm wrong, not an expert by any means.
They MIGHT fit. There are usually fitting issues. Not always but usually. Generally the issue is the pins not quite lined up.
I just built an 80%. no fitment issues. The rear pin is tight and needs to be tapped in and out. As long as everything is "milspec" it will fit without issues.
total cost was just under $600 without the shipping.
I highly recommend an armorer's wrench, a vice block, and a couple of roll pin punches to get everything installed.
Location: Approximately 50 miles from Missoula MT/38 yrs full time after 4 yrs part time
2,308 posts, read 4,120,376 times
Reputation: 5025
Couldn't be happier with a complete LMT UPPER W/ a NATO chambered match grade stainless , 8" twist barrel,flat top receiver, mated to a CMMG LOWER with match grade trigger and 6 position stock....all components Mil Spec. I
Please register to post and access all features of our very popular forum. It is free and quick. Over $68,000 in prizes has already been given out to active posters on our forum. Additional giveaways are planned.
Detailed information about all U.S. cities, counties, and zip codes on our site: City-data.com.