- Equipment/Food-Contact/Before Use After Cleaning/Sanitized (corrected on site)
Observation: The chlorine sanitizer at the 3-part sink was less than 50 ppm.
Correction: Utensils and food-contact surfaces of equipment shall be sanitized before use after cleaning. Sanitization is accomplished after the warewashing steps of cleaning and rinsing so that utensils and food-contact surfaces are sanitized before coming in contact with food and before use.
|
10/07/2015 | Risk Factor | |
- Time/Temperature Control for Safety Food, Cold Holding (repeated violation)
Observation: Half cooked chicken at 47 F inside the reach-in cooler.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
|
05/18/2015 | Risk Factor | |
- Packaged and Unpackaged Food-Separation, Packaging, and Segregation/Preventing Food and Ingredient Contamination (repeated violation)
Observation: Food containers inside cooling units are not covered.
Correction: Food shall be protected from cross contamination by storing the food in packages, covered containers, or wrappings. This section does not apply to: (1) Whole, uncut, raw fruits and vegetables and nuts in the shell, that require peeling or hulling before consumption
- Equipment and Utensils/Durability and Strength (repeated violation)
Observation: The microwave oven is not designed and constructed to be durable.
Correction: Equipment and utensils shall be designed and constructed to be durable and to retain their characteristic qualities under normal use conditions. Equipment and utensils must be designed and constructed to be durable and capable of retaining their original characteristics so that such items can continue to fulfill their intended purpose for the duration of their life expectancy and to maintain their easy cleanability. If they can not maintain their original characteristics, they may become difficult to clean, allowing for the harborage of pathogenic microorganisms, insects, and rodents. Equipment and utensils must be designed and constructed so that parts do not break and end up in food as foreign objects or present injury hazards to consumers. A common example of presenting an injury hazard is the tendency for tines of poorly designed single service forks to break during use.
- Handwashing Sink/Using/Operation and Maintenance
Observation: The back hand sink is blocked by a metal tray.
Correction: A handwashing sink shall be maintained so that it is accessible at all times for employee use. Facilities must be maintained in a condition that promotes handwashing and restricted for that use. Convenient accessibility of a handwashing facility encourages timely handwashing which provides a break in the chain of contamination from the hands of food employees to food or food-contact surfaces.
|
02/05/2015 | Routine | |
Todays inspection was a follow-up due to several priority violations. Substantial compliance observed. Please continue to keep establishment clean. Cleanliness in comparison to previous inspection is greatly noted.
- Floors, Walls, and Ceilings/Cleanability (repeated violation)
Observation: Grout in poor repair.
Correction: Floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed and installed so that they are smooth and easily cleanable except for anti-slip floor coverings or applications that may be used for safety reasons and except as specified under section 6-201.14. Floors that are of smooth, durable construction and that are nonabsorbent are more easily cleaned. Requirements and restrictions regarding floor coverings, utility lines, and floor/wall junctures are intended to ensure that regular and effective cleaning is possible and that insect and rodent harborage is minimized.
|
11/21/2014 | Follow-up | |
Facility will be reinspected on or about 31 October 2014 Joint inspection LC/KP
- Critical: Reheating for Hot Holding (corrected on site)
Observation: Cooked Chicken out at 63F. Corrected by reheating.
Correction: Time/temperature control for safety food that is cooked, cooled and reheated for hot holding shall be reheated so that all parts of the food reach a temperature of at least 74ºC (165ºF) for 15 seconds. When food is held, cooled, and reheated in a food establishment, there is an increased risk from contamination caused by personnel, equipment, procedures, or other factors. If food is held at improper temperatures for enough time, pathogens have the opportunity to multiply to dangerous numbers. Proper reheating provides a major degree of assurance that pathogens will be eliminated. The potential for growth of pathogenic bacteria is greater in reheated cooked foods than in raw foods. This is because spoilage bacteria, which inhibit the growth of pathogens by competition on raw product, are killed during cooking. Subsequent recontamination will allow pathogens to grow without competition if temperature abuse occurs.
- Critical: Time/Temperature Control for Safety Food, Cold Holding (corrected on site)
Observation: Fried chicken and egg rolls discovered in beverage cooler at 48-50F. Corrected by cooling.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Critical: Characteristics/Multiuse (corrected on site)
Observation: Metal banded paintbrush being used to put sauce on chicken. Corrected.
Correction: Materials that are used in the construction of utensils and food-contact surfaces of equipment may not allow the migration of deleterious substances or impart colors, odors, or tastes to food and under normal use conditions shall be safe. Multiuse equipment is subject to deterioration because of its nature, i.e., intended use over an extended period of time. Certain materials allow harmful chemicals to be transferred to the food being prepared which could lead to foodborne illness. In addition, some materials can affect the taste of the food being prepared. Surfaces that are unable to be routinely cleaned and sanitized because of the materials used could harbor foodborne pathogens.
- Equipment and Utensils/Durability and Strength
Observation: Non-commercial equipment being used for cooking food: Rice cooker, microwave.
Correction: Equipment and utensils shall be designed and constructed to be durable and to retain their characteristic qualities under normal use conditions. Equipment and utensils must be designed and constructed to be durable and capable of retaining their original characteristics so that such items can continue to fulfill their intended purpose for the duration of their life expectancy and to maintain their easy cleanability. If they can not maintain their original characteristics, they may become difficult to clean, allowing for the harborage of pathogenic microorganisms, insects, and rodents. Equipment and utensils must be designed and constructed so that parts do not break and end up in food as foreign objects or present injury hazards to consumers. A common example of presenting an injury hazard is the tendency for tines of poorly designed single service forks to break during use.
- Equipment/Good Repair and Proper Adjustment (repeated violation)
Observation: Beverage Air refrigerator not capable of maintaining foods at 41F. Ambient temp: 50F. Handle on rice cooker in poor repair.
Correction: Equipment shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 [Materials for Construction and Repair] and 4-2 [Design and Construction]. Proper maintenance of equipment to manufacturer specifications helps ensure that it will continue to operate as designed. Failure to properly maintain equipment could lead to violations of the associated requirements of the Code that place the health of the consumer at risk. For example, refrigeration units in disrepair may no longer be capable of properly cooling or holding potentially hazardous (time/temperature control for safety) foods at safe temperatures.
- Equipment, Food-Contact Surfaces, and Utensils
Observation: Ice dispenser observed with an accumulation of dirt and residue.
Correction: Equipment food-contact surfaces and utensils shall be clean to sight and touch. The objective of cleaning focuses on the need to remove organic matter from food-contact surfaces so that sanitization can occur.
- Refuse/Storage Areas, Rooms, and Receptacles, Capacity and Availability
Observation: There is no waste receptacle located at the hand washing sink.
Correction: If disposable towels are used at handwashing lavatories, a waste receptacle shall be located at each lavatory or group or adjacent lavatories. Garbage containers should be available wherever garbage is generated to aid in the proper disposal of refuse.
- Floors, Walls, and Ceilings/Cleanability
Observation: Grout in poor repair.
Correction: Floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed and installed so that they are smooth and easily cleanable except for anti-slip floor coverings or applications that may be used for safety reasons and except as specified under section 6-201.14. Floors that are of smooth, durable construction and that are nonabsorbent are more easily cleaned. Requirements and restrictions regarding floor coverings, utility lines, and floor/wall junctures are intended to ensure that regular and effective cleaning is possible and that insect and rodent harborage is minimized.
- Controlling Pests (Critical)
Observation: Alive and dead cockroaches were observed. Dead roaches observed smashed in each refrigerator door as well as actual refrigerator. .
Correction: The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by using methods, if pests are found, such as trapping devices or other means of pest control as specified under sections 7-202.12, 7-206.12, and 7-206.13. Insects and other pests are capable of transmitting disease to man by contaminating food and food-contact surfaces. Effective measures must be taken to control their presence in food establishments.
|
10/21/2014 | Routine | |
1. Hood filters and convection oven are in need of cleaning.
2. A nymph roach was observed crawling on back handwashing sink.
3. The piping under wash basin of 3-compartment sink is leaking.
4. Methods used for cooling cooked chicken can not be accomplished with the time and temperature criteria - (corrected).
5. Chlorine sanitizer in 3-compartment sink was at proper concentration.
- Critical: Potentially Hazardous Food, Cold Holding, Eggs (corrected on site)
Observation: Shell eggs not treated to destroy all viable Salmonellae were not stored in a refrigerated unit with an ambient air temperature of 45ºF or less. Raw eggs were stored in 2-dr glass sliding refrigerator which was observed at 50F.
Correction: (relocated) - Eggs that have not been treated to destroy all viable Salmonellae shall be stored in refrigerated equipment that maintains an ambient air temperature of 7ºC (45ºF) or less.
|
12/06/2013 | Risk Factor | |
1. Some fruit flies observed in the kitchen.
- Critical: Packaged and Unpackaged Food-Separation, Packaging, and Segregation/Preventing Food and Ingredient Contamination (corrected on site)
Observation: Ready-to-eat food is not protected from cross contamination by separating them from raw animal foods. Raw shrimps stored over vegetables in "Hobart" 2-dr refrigerator.
Correction: Food shall be protected from cross contamination by separating raw animal foods during storage, preparation, holding, and display from: (a) Raw ready-to-eat food including other raw animal food such as fish for sushi or molluscan shellfish, or other raw ready-to-eat food such as fruits and vegetables, and (b) Cooked ready-to-eat food.
- Cooling Methods (corrected on site)
Observation: Methods used for cooling for cooked chicken can not be accomplished with the time and temperature criteria.
Correction: Cooling shall be accomplished in accordance with the time and temperature criteria specified under section 3-501.14 by using one or more of the following methods based on the type of food being cooled: (1) Placing food in shallow pans
- Equipment/Fixed, Spacing or Sealing
Observation: Back handwashing sink is not sealed to the adjoining wall.
Correction: Counter-mounted equipment that is not easily movable shall be installed to allow cleaning of the equipment and areas underneath and around the equipment by being: (1) Sealed
- Equipment/Good Repair and Proper Adjustment (repeated violation)
Observation: The 2-dr glass sliding refrigerator and ice machine are not maintained in a state of repair and condition that meets the requirements of materials for construction and repair and/or design.
Correction: Equipment shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 [Materials for Construction and Repair] and 4-2 [Design and Construction]. Proper maintenance of equipment to manufacturer specifications helps ensure that it will continue to operate as designed. Failure to properly maintain equipment could lead to violations of the associated requirements of the Code that place the health of the consumer at risk. For example, refrigeration units in disrepair may no longer be capable of properly cooling or holding potentially hazardous (time/temperature control for safety) foods at safe temperatures.
- Intensity/Lighting
Observation: The light intensity is below 20 foot candles in 2-dr glass sliding refrigerator.
Correction: The light intensity shall be at least 215 lux (20 foot candles): (1) At a surface where food is provided for consumer self-service such as buffets and salad bars or where fresh produce or packaged foods are sold or offered for consumption, (2) Inside equipment such as reach-in and under-counter refrigerators
|
02/04/2013 | Routine | |
Restaurant representatives - add corrected or new information about Yeni's Dim Sum Plus, 4238 Wilson Blvd #160, Arlington, VA 22203 »