- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
09/08/2015 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
04/15/2015 | Inspection | |
No violation noted during this evaluation. | 03/18/2015 | Inspection | |
No violation noted during this evaluation. | 10/06/2014 | Re-Inspection | |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Improper thawing procedures used
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- In use food dispensing utensils improperly stored
- Critical: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Non food contact surfaces of equipment not clean
|
09/26/2014 | Inspection | |
No violation noted during this evaluation. | 04/08/2014 | Re-Inspection | |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- In use food dispensing utensils improperly stored
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- In use food dispensing utensils improperly stored
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Improper thawing procedures used
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Improper thawing procedures used
|
03/14/2014 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Pesticide application not supervised by a certified applicator
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
10/11/2013 | Inspection | |
- Hair is improperly restrained
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
03/22/2013 | Inspection | |
- Improper use and storage of clean, sanitized equipment and utensils
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
12/19/2012 | Re-Inspection | |
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
11/30/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
05/09/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
05/02/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Non food contact surfaces of equipment not clean
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Hair is improperly restrained
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Single service items reused, improperly stored, dispensed, not used when required
|
04/15/2011 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Non food contact surfaces of equipment not clean
|
10/18/2010 | Re-Inspection | |
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Non food contact surfaces of equipment not clean
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
10/15/2010 | Re-Inspection | |
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Critical: Canned foods found in poor conditions (leakers, severe dents, rusty, swollen cans)
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
10/08/2010 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Single service items reused, improperly stored, dispensed, not used when required
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Hair is improperly restrained
|
03/19/2010 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Cracked/dirty fresh eggs, liquid or frozen eggs and powdered eggs not pasteurized.
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Improper use and storage of clean, sanitized equipment and utensils
- Single service items reused, improperly stored, dispensed, not used when required
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Non food contact surfaces of equipment not clean
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
05/26/2009 | Inspection | Provided hand washing signs for frontdining room rest rooms. Provided and reviewed food fact sheet and reviewed proper cooling times and temperatures for roasts over 6 lbs. |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Hair is improperly restrained
- Non food contact surfaces of equipment not clean
|
05/23/2008 | Inspection | |
- Hair is improperly restrained
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Non food contact surfaces of equipment not clean
|
03/23/2007 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Non food contact surfaces of equipment not clean
|
03/03/2006 | Inspection | |
Restaurant representatives - add corrected or new information about Endwell Greens Golf Club, 3675 Sally Piper Road, Endwell, NY 13760 »