- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
01/12/2016 | Inspection | At the time of inspection, previous violations and facility concerns were discussed with the facility manager. |
- Critical: Food workers do not use proper utensils to eliminate bare hand contact with cooked or prepared foods.
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
11/04/2015 | Re-Inspection | The purpose of this inspection was to re-inspect the items noted on the previous report on September 11, 2015. Several items were reviewed at the time of this visit including: Maintenance of all cold holding equipment, using proper barriers to prevent bare hand contact with ready to eat foods.
Due to the above repeat red violations the Department may take an Enforcement Action against the facility.o |
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
|
09/11/2015 | Inspection | |
- Critical: Food workers do not use proper utensils to eliminate bare hand contact with cooked or prepared foods.
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
03/12/2015 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
12/04/2014 | Inspection | At the time of inspection it was stated that the facility is hoping to upgrade their beer coolers. Before this occurs the Department will need a completed DOH-154 Notice Of Intent form completed and submitted to the Department. |
- Improper thawing procedures used
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
|
02/04/2014 | Inspection | |
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Single service items reused, improperly stored, dispensed, not used when required
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
11/26/2013 | Inspection | Note: The items listed in this inspection report may result in an enforcement action from this department. |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Critical: Foods or food area/public area contamination by sewage or drippage from waste lines.
|
04/09/2013 | Inspection | |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- In use food dispensing utensils improperly stored
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Critical: Potentially hazardous foods are not kept at or above 140oF during hot holding.
- Critical: Enough hot holding equipment is not present, properly designed, maintained and operated to keep hot foods above 140oF.
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Improper use and storage of clean, sanitized equipment and utensils
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
- Single service items reused, improperly stored, dispensed, not used when required
|
12/11/2012 | Inspection | |
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Wiping cloths dirty, not stored properly in sanitizing solutions
|
02/06/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
01/31/2011 | Re-Inspection | |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
01/10/2011 | Inspection | |
- Improper use and storage of clean, sanitized equipment and utensils
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Single service items reused, improperly stored, dispensed, not used when required
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
|
01/19/2010 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
01/14/2009 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
03/18/2008 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
10/19/2007 | Inspection | |
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Critical: Food from unapproved source, spoiled, adulterated on premises.
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Tobacco is used; eating, drinking in food preparation, dishwashing food storage areas
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
- Non food contact surfaces of equipment not clean
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
|
06/28/2007 | Inspection | |
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
06/26/2006 | Inspection | |
Restaurant representatives - add corrected or new information about Macgregors Grill & Tap Room, 759 South Main Street, Canandaigua, NY 14424 »