- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non food contact surfaces of equipment not clean
- Critical: Canned foods found in poor conditions (leakers, severe dents, rusty, swollen cans)
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
02/19/2016 | Inspection | |
| No violation noted during this evaluation. | 02/17/2016 | Inspection | tube guards for lighting, enclosed paper towel dispenser in bathroom have been corrected, owner wanted to know about vacuum sealing foods for freezing and was instructed it is not allowed without an approved scheduled process or recipe plan. gloves, sanitizer and choking poster ok. |
| No violation noted during this evaluation. | 02/10/2016 | Inspection | CFW Kevin Curtis. N.R. exp.12/8/2019
Doug Wrend. N.R. exp. 12/8/2019
Satisfactory temps |
- Critical: Potentially hazardous foods are not kept at or above 140oF during hot holding.
|
02/05/2016 | Inspection | Part 1- One Red Violation Observed.
Part 2- No blue violations observed.
A reinspection will be conducted in 2-3 weeks. |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
01/28/2016 | Inspection | Discussed pizza holding procedures; operation uses a heated cabinet, but also discards pizzas after 2-hours of holding. Hood over cookline has been recently cleaned. Digital thermometer utilized. Hair restraints and hand barriers utilized. Choking poster, cpr station and permit are hung. Mentioned ServSafe training being held at MCDOH. |
| No violation noted during this evaluation. | 01/25/2016 | Inspection | food worker required 2016 |
- Hot, cold running water not provided, pressure inadequate
|
01/22/2016 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
|
01/20/2016 | Inspection | CFW - Alecia Werder exp. 4/29/20-
-all temperatures taken were satisfactory |
- Non food contact surfaces of equipment not clean
|
01/06/2016 | Inspection | No reinspection required. |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
02/26/2015 | Inspection | |
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
|
02/02/2015 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
|
02/24/2014 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
02/21/2014 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
03/26/2013 | Re-Inspection | |
- Hot, cold running water not provided, pressure inadequate
|
03/13/2013 | Inspection | |
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
03/06/2013 | Inspection | |
- Non food contact surfaces of equipment not clean
|
04/20/2012 | Inspection | |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Wiping cloths dirty, not stored properly in sanitizing solutions
|
02/17/2012 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
05/04/2011 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
03/17/2011 | Re-Inspection | |
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
03/02/2011 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Garbage storage areas not properly constructed or maintained, creating a nuisance
|
05/18/2010 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
02/25/2010 | Inspection | |
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
06/11/2009 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Insects, rodents present
|
04/02/2009 | Re-Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non food contact surfaces of equipment not clean
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Improper use and storage of clean, sanitized equipment and utensils
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Insects, rodents present
|
03/10/2009 | Inspection | |
Restaurant representatives - add corrected or new information about Mark's Pizzeria, 2103 Buffalo Road, Rochester, NY 14624 »