- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
|
12/14/2015 | Inspection | |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
03/16/2015 | Inspection | Temperatures measured: deli cooler (top): diced tomatoes = 40 deg. F, shredded cheese = 43 deg. F, cooked ground beef = 43 deg. F, hot holding marinara = 158 deg. F, macaroni salad in reach in cooler = 39 deg. F. |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
09/23/2014 | Inspection | All hot and cold holding temperatures were adiquate. |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
|
06/12/2014 | Inspection | All hot and cold food temperatures measured with the DOH thermocouple : meat marinara, beef & turkey gravies, hot cheese sauce, cold sliced & diced tomatoes, cole slaw, raw chicken, were acceptable. It's recommended that a thermocouple thermometer or at least a digital food probe thermometer be obtained for this operation. The Thermapen company has good basic thermocouples for instant & accurate food temperature measurements with no calibration needed. |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
11/27/2013 | Inspection | The kitchen will be undergoing renovations in the spring of 2014. |
- Non food contact surfaces of equipment not clean
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
|
09/26/2013 | Inspection | All of the hot & cold hold temperatures measured with the DOH thermocouple were 140 degrees or above & 45 degrees or below respectively. Recommend obtaining a thermocouple thermometer for this operation. |
- Critical: Potentially hazardous foods are not kept at or above 140oF during hot holding.
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
|
10/04/2012 | Inspection | |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
04/04/2012 | Inspection | |
- Non food contact surfaces of equipment not clean
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
12/12/2011 | Inspection | |
- Non food contact surfaces of equipment not clean
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
12/23/2010 | Inspection | |
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
11/27/2009 | Inspection | |
| No violation noted during this evaluation. | 02/17/2009 | Re-Inspection | |
| No violation noted during this evaluation. | 12/26/2008 | Re-Inspection | |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
12/01/2008 | Inspection | |
- Non food contact surfaces of equipment not clean
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
12/18/2007 | Inspection | |
| No violation noted during this evaluation. | 02/22/2007 | Re-Inspection | |
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
|
01/19/2007 | Inspection | |
- Critical: Food workers do not use proper utensils to eliminate bare hand contact with cooked or prepared foods.
|
12/29/2005 | Inspection | |
Restaurant representatives - add corrected or new information about Wiseguys, 11 School Street, Lake Placid, NY 12946 »