- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Non food contact surfaces of equipment not clean
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
|
12/30/2015 | Inspection | Temperatures measured: beef sirloin = 41 deg. F, raw shrimp = 38 deg. F. |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
|
06/04/2015 | Inspection | Vacuum packaging equipment was observed stored by the ice cream freezer in the rear side room. Per discussions with the owner and cook, vacuum packaging is only being done by staff for personal foods. No vacuum packaged foods were observed in storage or refrigeration. The unit was packaged and removed form the facility and education was provided. Installation of a 3 bay sink is strongly recommended. if there are any kitchen renovations. |
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
12/19/2014 | Inspection | The mop water must be transported to the basement sink which is exclusively used to dump mop water and for utility purposes. 3 bay dishwashing must be completed in the food prep sink by the stove and hood. staff must be made aware that dishes must first be washed with warm soapy water (can be done in a bus bucket), rinsed with clean tap water, and sanitized in a sink of sanitizing solution. |
- Non food contact surfaces of equipment not clean
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
09/17/2014 | Re-Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- In use food dispensing utensils improperly stored
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
|
06/03/2014 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Premises littered, unnecessary equipment and article present, living quarters no completely separated for food service operations, live animals, birds and pets not excluded
|
10/22/2013 | Inspection | Reviewed the cooling and reheating procedures and processes. Monitoring logs are well maintained. Reinspection in February 2014 |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Premises littered, unnecessary equipment and article present, living quarters no completely separated for food service operations, live animals, birds and pets not excluded
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
02/22/2013 | Inspection | |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Improper use and storage of clean, sanitized equipment and utensils
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
- Miscellaneous, Economic Violation, Choking Poster, Training.
|
10/24/2012 | Inspection | |
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Pesticide application not supervised by a certified applicator
- Improper use and storage of clean, sanitized equipment and utensils
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Non food contact surfaces of equipment not clean
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
03/20/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
12/22/2011 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
05/26/2011 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
05/05/2010 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Hair is improperly restrained
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
09/01/2009 | Inspection | |
- Premises littered, unnecessary equipment and article present, living quarters no completely separated for food service operations, live animals, birds and pets not excluded
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
03/10/2009 | Inspection | |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Wiping cloths dirty, not stored properly in sanitizing solutions
|
03/13/2008 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
03/20/2007 | Inspection | |
| No violation noted during this evaluation. | 03/17/2006 | Inspection | |
Restaurant representatives - add corrected or new information about Cavallo's Belvedere, 102 Bloomingdale Avenue, Saranac Lake, NY 12983 »