- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
11/13/2015 | Re-Inspection | ALL VIOLATIONS ADDRESSED AND CORRECTED EXCEPT FOR THE WALK IN DOORS. AND HOOD VENT FILTERS. WALK IN DOORS AND FILTERS MUST BE REPAIRED BY NEXT ROUTINE INSPECTION 2016 |
| No violation noted during this evaluation. | 10/26/2015 | Re-Inspection | REINSPECTION FOR CRITICAL VIOLATIONS ONLY. AT THIS TIME ALL CRITICAL VIOLATIONS HAVE BEEN ADDRESSED AND CORRECTED. ELETRIC HOT HOLDING UNITS WILL BE REPAIRED.
REINSPECTION FOR BLUE VIOLATIONS FROM 10-21-15 INSPECTION WILL BE CONDUCTED ON NOVEMBER 13, 2015 |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- In use food dispensing utensils improperly stored
- Critical: Enough hot holding equipment is not present, properly designed, maintained and operated to keep hot foods above 140oF.
- Critical: Potentially hazardous foods are not kept at or above 140oF during hot holding.
- Critical: Potentially hazardous foods are not stored under refrigeration except during necessary preparation or approved precooling procedures (room temperature storage).
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
|
10/21/2015 | Inspection | REINSPECTION FOR CRITICAL VIOLATIONS ON MONDAY OCTOBER 26, 2015
REINSPECTION FOR ALL BLUE ITEMS 2 WEEKS
***ALL HOT HOLDING MUST BE @ OR ABOVE 140DEGF AT ALL TIMES. 140DEGF WATER MUST BE USED TO FILL STEAAM TABLES AND TABLES MUST BE HOT ENOUGH TO KEEP FOODS AT THE CORRECT TEMP.
THE ELETRIC HOT HOLDING DEVICES THAT ARE CURRENTLY NOT WORKING MUST BE REPAIRED, REPLACED, OR REMOVED AND CN NOT BE USED.
THE WALK IN FREEZER DOOR GASKETS ARE NOT SEALING AND CAUSING A HEAVY BUILDUP OF ICE ON THE PRODUCTS.
ALL WALK IN DOOR GASKETS AND SPRINGS TO BE CHECKED SO UNITS ARE SEALED. |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Hot, cold running water not provided, pressure inadequate
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
02/10/2015 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Hot, cold running water not provided, pressure inadequate
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Non food contact surfaces of equipment not clean
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- In use food dispensing utensils improperly stored
|
12/02/2014 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
05/01/2014 | Re-Inspection | |
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Potentially hazardous foods are not kept at or above 140oF during hot holding.
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Non food contact surfaces of equipment not clean
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
04/28/2014 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
09/19/2013 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
03/25/2013 | Inspection | |
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
09/21/2012 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
04/25/2012 | Inspection | |
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Improper thawing procedures used
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
|
10/05/2011 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
03/08/2011 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
11/03/2010 | Inspection | |
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
01/27/2010 | Inspection | |
| No violation noted during this evaluation. | 09/15/2009 | Inspection | |
| No violation noted during this evaluation. | 09/11/2009 | Re-Inspection | |
Restaurant representatives - add corrected or new information about Sarah Lawrence College - Bates Dinin, 1 Mead Way, Bronxville, NY 10708 »