- Critical: Food - Potentially Hazardous Food - Cold Holding* (corrected on site)
Observation: Butter cold holding at improper temperatures
Correction: Relocate food to a refrigeration unit that is capable of maintaining food storage at 41°F or below or discard.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent (corrected on site) (repeated violation)
Observation: The nonfood contact surface of the freezer is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the cooler has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
|
03/16/2016 | Routine | |
- Person in Charge (corrected on site)
Observation: Customer entering the food preparation, food storage, and/or warewashing areas are not in compliance with this Regulation.
Correction: Establish a barrier to food contamination by Informing employees, delivery and maintenance persons and pesticide applicators to comply with this Regulation when entering areas of the food establishment where food and food contact items are exposed. Individuals present in areas of a food establishment where food and food contact items are exposed presents a potential contamination risk.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent
Observation: The nonfood contact surface of the refrigerator is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Temperature Measuring Devices
Observation: There was no temperature measuring device located in the prep table or refrigeratorin back area.
Correction: Provide a temperature measuring device in all hot or cold holding equipment used to store potentially hazardous foods so that employees can routinely monitor the ambient air temperature.
|
09/21/2015 | Routine | |
- Critical: Package Integrity* (corrected on site)
Observation: Food packages are not in good condition or the integrity of the package contents are not protected from adulteration or potential contaminants (ex: dented food cans)
Correction: Discard or return to distributor any food packages that are not in good condition or the integrity of the package contents are not protected from adulteration or potential contaminants.
- Gloves - Use Limitation (corrected on site)
Observation: Unapproved slash-resistant gloves used for cutting ready-to-eat food (RTE).
Correction: Use only those slash-resistant gloves that have a smooth, durable and nonabsorbent outer surface with RTE food. Absorbent and hard to clean slash-resistant gloves may be used with RTE food if they are covered with a smooth, durable, nonabsorbent glove or a single-use glove.
- Thawing (corrected on site)
Observation: Improper methods used to thaw whipped cream.
Correction: Thaw potentially hazardous foods by either of the following methods: 1. Under refrigeration that maintains food temperature at 41°F (45°F) 2. Completely submerged under running water at a temperature of 70°F or below with sufficient water velocity to agitate and float off loose particles in an overflow. Ready-to-eat food shall not exceed 41°F and raw animal foods shall not exceed 41°F for more than four hours 3. As part of the cooking process
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the hood,stove, wall at syove, andrefrigerator has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Premises - Maintaining Premises - Unnecessary Items and Litter
Observation: Facility is storing unnecessary items to the operation or maintenance of the establishment.
Correction: Remove all unnecessary items from the facility. The presence of unnecessary articles, including equipment which is no longer used, makes regular and effective cleaning more difficult and less likely. It can also provide harborage for insects and rodents.
|
03/18/2015 | Routine | |
- Critical: Equipment - Food Contact Surfaces and Utensils (corrected on site)
Observation: Food contact surfaces of the can opener used to prepare/store potentially hazardous food items were observed soiled with accumulations of food residues.
Correction: Clean food-contact surfaces of can opener no less than every 4 hours to prevent the growth microorganisms on those surfaces.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the grill, mixer, slicer and other equipment has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floor in the kitchen and storage room noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
09/08/2014 | Routine | |
- Non-Food Contact Surfaces
Observation: The nonfood contact surface of the hood filters in hood, ansul system, grill, and stove has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Physical Facilities - Cleaning Frequency and Restrictions
Observation: Floor in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
03/07/2014 | Routine | |
Corrections made, slicer cleaned and pots, pans, other equipment stored properly
No violation noted during this evaluation. | 09/17/2013 | Follow-up | |
Slicer not properly cleaned nor equipment properly stored.
- Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils
Observation: Observed accumulations of dust, dirt, food residue or other debris on the following nonfood-food contact surfaces: pots, pans,trays.
Correction: Maintain nonfood-contact surfaces of equipment clean.
- Critical: Equipment - Food Contact Surfaces and Utensils (repeated violation)
Observation: Food contact surfaces of the slicer used to prepare/store potentially hazardous food items were observed soiled with accumulations of food residues.
Correction: Clean food-contact surfaces of slicer no less than every 4 hours to prevent the growth microorganisms on those surfaces.
|
09/16/2013 | Follow-up | |
- Food Storage - Clean and Dry Location (corrected on site) (repeated violation)
Observation: Food stored in a location where it is subject to splash, dust or other contamination.
Correction: Store food where it is not exposed to splash or install an approved durable, and cleanable barrier between the splash source and the food to prevent contamination.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent
Observation: The nonfood contact surface of the "TRUE" cooler is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Critical: Equipment - Food Contact Surfaces and Utensils
Observation: Food contact surfaces of the slicer used to prepare/store potentially hazardous food items were observed soiled with accumulations of food residues.
Correction: Clean food-contact surfaces of slicer no less than every 4 hours to prevent the growth microorganisms on those surfaces.
- Kitchenware and Tableware (corrected on site)
Observation: Plates, saucers,pots, pans, bowls and glassware were found handled, displayed or dispensed with the food or lip-contact surface facing upward.
Correction: Store plates, saucers,pots, pans, bowls, and glassware with food or lip-contact surface facing downward to prevent contamination prior to use.
- Critical: Backflow Prevention Device, When Required* (corrected on site) (repeated violation)
Observation: Observed a hose attached to a faucet fixture. The hose extended below the flood rim level of the sink basin.
Correction: Install an approved backflow prevention device or alter the length of the hose to provide the necessary separation between the water supply and the flood rim level of the sink basin. The minimum allowable separation distance must be at least 2x the diameter of the water supply inlet and at least 1 inch.
- Maintenance Tools - Storing Maintenance Tools (corrected on site)
Observation: Mop, broom,dust pan noted to be stored in such a way that it is contaminating equipment
Correction: Maintenance equipment supplies and tools such as brooms, mops, vacuum cleaners, and similar items must be stored so they do not contaminate food equipment, utensils, linens, and single-service and single-use articles.
|
09/06/2013 | Routine | |
- Food Storage - Clean and Dry Location (corrected on site)
Observation: Food stored in a location where it is subject to splash, dust or other contamination.
Correction: Store food where it is not exposed to splash or install an approved durable, and cleanable barrier between the splash source and the food to prevent contamination.
- Warewashing Equipment, Determining Chemical Sanitizer Concentration
Observation: A sanitizer test kit is not being used to ensure the chemical sanitizing solution(s) are at the proper concentration.
Correction: Use a chlorine chemical test kit to ensure the sanitizing solution is maintained at the proper solution.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the cooler compressor has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Critical: Backflow Prevention Device, When Required* (corrected on site)
Observation: Observed a hose attached to a faucet fixture. The hose extended below the flood rim level of the sink basin.
Correction: Install an approved backflow prevention device or alter the length of the hose to provide the necessary separation between the water supply and the flood rim level of the sink basin. The minimum allowable separation distance must be at least 2x the diameter of the water supply inlet and at least 1 inch.
- Floors, Walls, and Ceilings - Cleanability
Observation: Floor or floor covering in storage area is not smooth and easily cleanable.
Correction: Repair or replace floor or floor covering to make it smooth and easily cleanable.
- Employee Accommodations, Designated Areas (corrected on site)
Observation: Locker or other suitable facilities are not located to protect food from contamination
Correction: Locate lockers or other suitable facilities so that food, equipment, single-service and single-use articles to protect them from contamination
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floor in the entire food prep, storage, dishwashing, and cooking area noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
03/14/2013 | Routine | |
- Critical: Food - Packaged and Unpackaged - Separation, Packaging, and Segregation*
Observation: Unwrapped or uncovered food in the storage room.
Correction: Protect food from cross contamination by storing food in packages, covered containers, or wrappings.
- Food Storage - Clean and Dry Location (repeated violation)
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the equipment has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Pests - Controlling Pests* (repeated violation)
Observation: Methods are not being used to control pests
Correction: When pests are found use methods to such as trapping devices or other means of pest control. Insects and other pests are capable of transmitting disease to man by contaminating food and food-contact surfaces.
|
09/21/2011 | Critical Procedures | |
Restaurant representatives - add corrected or new information about Abingdon Senior Center, 300 Senior Drive, Abingdon, VA 24210 »