- Critical: Backflow Prevention
- Comment:
- THERE IS AN INCH AIR GAP PROVIDED AT SODA MACHINE. CORRECTED.
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Handwashing Signage
- Comment:
- HAND WASHING SIGNAGE IS PROVIDED AT HAND WASH SINK IN BAR AREA. CORRECTED.
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
- Critical: Backflow Prevention
- Comment:
- THERE IS AN INCH AIR GAP PROVIDED AT SODA MACHINE. CORRECTED.
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Handwashing Signage
- Comment:
- HAND WASHING SIGNAGE IS PROVIDED AT HAND WASH SINK IN BAR AREA. CORRECTED.
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
|
12/19/2014 | Follow-up |
- Critical: Backflow Prevention
- Items:
- Backflow/backsiphonage prevention device(s)
- Problems:
- Not provided on
- Corrections:
- Provide adequate air gap.
- Comment:
- OBSERVED SODA MACHINE DRAINAGE LINE INSIDE FLOOR DRAIN BEHIND FOOD COUNTER. THERE MUST BE AN AIR GAP PROVIDED ON EQUIPMENT THAT STORES FOOD TO PREVENT CONTAMINATION FROM POSSIBLE BACK FLOW. PROVIDE AN INCH AIR GAP AT SODA MACHINE.,
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Critical: Food Temperature Measuring Dev
- Items:
- Food thermometer(s)
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- OBSERVED NO FOOD THERMOMETER INSIDE FACILITY. A FOOD MEASURING DEVICE MUST BE AVAILABLE AT ALL TIMES FOR THE ATTAINMENT AND MAINTENANCE OF FOOD TEMPERATURES. FOOD THERMOMETER PROVIDED AT THE END OF WRITE-UP. CORRECTED.
- General violation description:
- 4-302.12 - (A) FOOD TEMPERATURE MEASURING DEVICES shall be provided and readily accessible for use in ensuring attainment and maintenance of FOOD temperatures as specified under Chapter 3. (Pf) (B) A TEMPERATURE MEASURING DEVICE with a suitable small-diameter probe that is designed to measure the temperature of thin masses shall be provided and readily accessible to accurately measure the temperature in thin FOODS such as MEAT patties and FISH filets. (Pf)
- Drying Mops
- Comment:
- OBSERVED MOP HEADS LEANING AGAINST THE WALLS OF THE MOP SINK. MOPS MUST BE HUNG OVER DRAIN TO PROPERLY AIR DRY. HANG MOPS OVER DRAIN. VERIFY CORRECTION AT NEXT INSPECTION.
- General violation description:
- 6-501.16 - After use, mops shall be placed in a position that allows them to air-dry without soiling walls, EQUIPMENT, or supplies.
- Handwashing Signage
- Items:
- Handwashing signage
- Problems:
- Not provided
- Corrections:
- A designated employee storage/locker area shall be provided and used.
- Comment:
- HAND WASH SIGNAGE IS NOT PROVIDED AT HAND WASHING SINK IN BAR AREA. A HAND WASHING SIGN MUST BE PROVIDED TO REMIND FOOD EMPLOYEES TO WASH THEIR HANDS. PROVIDE SIGNAGE. VERIFY CORRECTION AT NEXT INSPECTION.,
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
- Critical: Backflow Prevention
- Items:
- Backflow/backsiphonage prevention device(s)
- Problems:
- Not provided on
- Corrections:
- Provide adequate air gap.
- Comment:
- OBSERVED SODA MACHINE DRAINAGE LINE INSIDE FLOOR DRAIN BEHIND FOOD COUNTER. THERE MUST BE AN AIR GAP PROVIDED ON EQUIPMENT THAT STORES FOOD TO PREVENT CONTAMINATION FROM POSSIBLE BACK FLOW. PROVIDE AN INCH AIR GAP AT SODA MACHINE.,
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Critical: Food Temperature Measuring Dev
- Items:
- Food thermometer(s)
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- OBSERVED NO FOOD THERMOMETER INSIDE FACILITY. A FOOD MEASURING DEVICE MUST BE AVAILABLE AT ALL TIMES FOR THE ATTAINMENT AND MAINTENANCE OF FOOD TEMPERATURES. FOOD THERMOMETER PROVIDED AT THE END OF WRITE-UP. CORRECTED.
- General violation description:
- 4-302.12 - (A) FOOD TEMPERATURE MEASURING DEVICES shall be provided and readily accessible for use in ensuring attainment and maintenance of FOOD temperatures as specified under Chapter 3. (Pf) (B) A TEMPERATURE MEASURING DEVICE with a suitable small-diameter probe that is designed to measure the temperature of thin masses shall be provided and readily accessible to accurately measure the temperature in thin FOODS such as MEAT patties and FISH filets. (Pf)
- Drying Mops
- Comment:
- OBSERVED MOP HEADS LEANING AGAINST THE WALLS OF THE MOP SINK. MOPS MUST BE HUNG OVER DRAIN TO PROPERLY AIR DRY. HANG MOPS OVER DRAIN. VERIFY CORRECTION AT NEXT INSPECTION.
- General violation description:
- 6-501.16 - After use, mops shall be placed in a position that allows them to air-dry without soiling walls, EQUIPMENT, or supplies.
- Handwashing Signage
- Items:
- Handwashing signage
- Problems:
- Not provided
- Corrections:
- A designated employee storage/locker area shall be provided and used.
- Comment:
- HAND WASH SIGNAGE IS NOT PROVIDED AT HAND WASHING SINK IN BAR AREA. A HAND WASHING SIGN MUST BE PROVIDED TO REMIND FOOD EMPLOYEES TO WASH THEIR HANDS. PROVIDE SIGNAGE. VERIFY CORRECTION AT NEXT INSPECTION.,
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
|
11/26/2014 | Routine |
Restaurant representatives - add corrected or new information about Taylor Fun And Fitness Llc, 23269 Eureka Rd, Taylor, MI 48180 »