- Critical: Potentially Hazardous Food (Ti
- Comment:
- Observed at time of inspection pepperoni, cheese, ham at 41 F or below in prep cooler. Corrected.
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
|
05/06/2015 | Follow-up |
- Critical: Equipment Food-Contact Surface
- Items:
- Food-contact surface(s) and utensil(s)
- Problems:
- Not cleaned
- Corrections:
- Clean as specified above.
- Comment:
- Observe at time of inspection employee stated can opener blade was used every day and was cleaned every week. Observed blade had dried up food particles on it. Can opener blade should be cleaned after every use. Correct at time of inspection employees were informed to wash can opener after every use. Can opener was removed to be cleaned.
- General violation description:
- 4-602.11 - (A) EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned: (1) Except as specified in (B) of this section, before each use with a different type of raw animal FOOD such as beef, FISH, lamb, pork, or POULTRY
- Critical: Potentially Hazardous Food (Ti
- Items:
- Cold food item(s)
- Problems:
- Stored above 41 degrees f
- Corrections:
- Store below 41 degrees F.
- Comment:
- Observed at time of inspection pepperoni, ham, mozzarella cheese, cut lettuce, cut tomato at 55 F. All potentially hazardous cold food must be held at 41 F or below. Food has been out of temperature for about an hour. Correct immediately by holding potentially hazardous cold food at 41 F or below. Food was moved to walk in cooler for rapid cooling. A follow will occur in about 10 days to make sure food is held at 41 F or below. ,
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
- Effectiveness
- Items:
- Hair restraint
- Problems:
- Not worn on head/hair
- Corrections:
- Provide hat or hair net.
- Comment:
- Observed at time of inspection employees preparing food without hats/hair restraints. Correct by providing as soon as possible a follow up will occur at the next routine inspection.
- General violation description:
- 2-402.11 - (A) Except as provided in # (B) of this section, FOOD EMPLOYEES shall wear hair restraints such as hats, hair coverings or nets, beard restraints, and clothing that covers body hair, that are designed and worn to effectively keep their hair from contacting exposed FOOD
|
04/17/2015 | Routine |
- Critical: Sanitizing Solutions, Testing
- Comment:
- CHLORINE TEST STRIPS WERE PURCHASED AND THE VIOLATION HAD BEEN CORRECTED.
- General violation description:
- 4-302.14 - A test kit or other device that accurately measures the concentration in MG/L of SANITIZING solutions shall be provided. (Pf)
|
05/01/2014 | Follow-up |
- Critical: Sanitizing Solutions, Testing
- Items:
- Sanitizer test kit
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- BUY CHLORINE TEST STRIPS TO FIND THE CONCENTRATION OF THE SANITIZER SOLUTION. TOO LESS(LESS THAN 25PPM MAY NOT SANITIZE THE DISHES PROPERLY AND MORE THAN 200 PPM MAY BE TOXIC. A FOLLOW UP INSPECTION WILL BE CONDUCTED WITH IN 10 DAYS.
- General violation description:
- 4-302.14 - A test kit or other device that accurately measures the concentration in MG/L of SANITIZING solutions shall be provided. (Pf)
|
04/24/2014 | Routine Inspection |
- Critical: Backflow prevention
- Comment:
- CORRECTED BY CUTTING DRAIN PIPE TO FORM AN AIR GAP.
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Critical: Eating, Drinking or Tobacco
- Comment:
- CORRECTED BY PROVIDING LIDS AND STRAWS ON EMPLOYEE CUPS. STORED AWAY FROM WORKING AREAS.
- General violation description:
- 2-401.11 - (A) Except as specified in (B) of this section, an EMPLOYEE shall eat, drink, or use any form of tobacco only in designated areas where the contamination of exposed FOOD
|
05/08/2012 | Follow-up |
- Critical: Backflow prevention
- Items:
- Backflow/backsiphonage prevention device(s)
- Locations:
- 3-compartment sink(s) food prep sink
- Problems:
- Not provided on
- Corrections:
- Provide adequate air gap.
- Comment:
- PROVIDE AN AIR GAP OF AT LEAST 2 TIMES THE PIPE DIAMETER ON THE 3-C SINK AS DISCUSSED.
- General violation description:
- 5-402.11 - (A) Except as specified in (B) and (C) of this section, a direct connection may not exist between the SEWAGE system and a drain originating from EQUIPMENT in which FOOD, portable EQUIPMENT, or UTENSILS are placed. (B) If allowed by LAW, a WAREWASHING machine may have a direct connection between its waste outlet and a floor drain when the machine is located within 1.5 m (5 feet) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap. (C) If allowed by LAW, a WAREWASHING or culinary sink may have a direct connection.
- Critical: Eating, Drinking or Tobacco
- Items:
- Employee(s)
- Locations:
- food prep table
- Problems:
- Drinking From uncovered beverage container
- Corrections:
- Beverage container must be covered.
- Comment:
- UNCOVERED EMPLOYEE BEVERAGE: 1) PROVIDE A CUP WITH LID AND STRAW OR HANDLE AND LID TO MINIMIZE THE RISK OF MOUTH TO CUP TO HAND TO FOOD CONTAMINATION. 2) STORE BELOW/AWAY FROM FOOD/FOOD CONTACT SURFACES.
- General violation description:
- 2-401.11 - (A) Except as specified in (B) of this section, an EMPLOYEE shall eat, drink, or use any form of tobacco only in designated areas where the contamination of exposed FOOD
- Wiping Cloths, Use Limitation
- Items:
- Wiping cloth(s) wet
- Locations:
- food prep area
- Problems:
- Stored on Counter
- Corrections:
- Store wiping cloths completely submersed in sanitizer.
- General violation description:
- 3-304.14 - (A) Cloths in-use for wiping food spills from TABLEWARE and carry-out containers that occur as FOOD is being served shall be: (1) Maintained dry
|
04/17/2012 | Routine Inspection |
| No violation noted during this evaluation. | 04/20/2011 | Routine Inspection |
- Temperature Measuring Devices
- Items:
- Thermometer(s) refrigeration
- Problems:
- Not easily readable
- Corrections:
- Repair/replace.
- Comment:
- PROVIDE REACH IN COOLER WITH A COOLER THERMOMETER
- General violation description:
- 4-204.112 - (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Except as specified in # (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURNG DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars. (D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1°C or 2°F in the intended range of use.(Pf)
- Temperature Measuring Devices
- Items:
- Thermometer(s) refrigeration
- Problems:
- Not easily readable
- Corrections:
- Repair/replace.
- Comment:
- PROVIDE REACH IN COOLER WITH A COOLER THERMOMETER
- General violation description:
- 4-204.112 - (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Except as specified in # (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURNG DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars. (D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1°C or 2°F in the intended range of use.(Pf)
|
09/30/2010 | Routine Inspection |
| No violation noted during this evaluation. | 10/06/2009 | Follow-up |
- Critical: Ready-to-Eat Food, Date Markin
- Items:
- In house prepared ready-to-eat potentially hazardous food(s)
- Problems:
- Without date of consumption marking
- Corrections:
- Provide proper date marks as stated above.
- Comment:
- PROVIDE DISCARD OR PREP DATES ON SLICED SALAMI AND TURKEY STORED IN THE WALK IN COOLER AND REACH IN COOLER.
- General violation description:
- 3-501.17 - (A) Except as specified in (E) of this section, refrigerated, READY-TO-EAT, POTENTIALLY HAZARDOUS FOOD prepared and held refrigerated for more than 24 hours in a FOOD ESTABLISHMENT shall be clearly marked at the time of preparation to indicate the date by which the FOOD shall be consumed which is, including the day of preparation: (1) 7 calendar days or less from the day that the FOOD is prepared, if the FOOD is maintained at 5C (41F) or less
- Determining Chem.San.Concentra
- Items:
- Sanitizer test kit
- Problems:
- Not used
- Corrections:
- Use test kit to verify sanitizer concentration.
- General violation description:
- 4-501.116 - Concentration of the SANITIZING solution shall be accurately determined by using a test kit or other device.(Pf)
- Wiping Cloths, Use Limitation
- Items:
- Wiping cloth(s)
- Problems:
- Not completely submerged in sanitizing solution
- Corrections:
- Store wiping cloths completely submersed in sanitizer.
- General violation description:
- 3-304.14 - (A) Cloths in-use for wiping food spills from TABLEWARE and carry-out containers that occur as FOOD is being served shall be: (1) Maintained dry
|
09/17/2009 | Routine Inspection |
Restaurant representatives - add corrected or new information about Toarminas Pizza, 3700 N Lilley, Canton, MI 48187 »