- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- In use food dispensing utensils improperly stored
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Wiping cloths dirty, not stored properly in sanitizing solutions
- Non food contact surfaces of equipment not clean
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
|
12/23/2015 | Inspection | All hot and cold food temperatures measured with a metal stem food probe thermometer are acceptable at 140 degrees F or above, and 45 degrees F or below respectively. At least one digital or thermocouple metal stem food probe thermometer must be obtained for this operation. Make sure any make shift cold hold set ups have a sufficient level of ice so that the level is enough to surround up to the top of any food product in the containers. Recommend initially adding a small amount of water and salt when setting up. Recommend lightening up on the strength concentration of the bleach water sanitizer mixtures. Proper strength concentration for any sanitizer when mixed and tested with the proper chemical test strip is 50-200ppm maximum. A compliance date of 2/1/2016 will be set for all violations except the cooler floors which will be 6/1/16 to avoid enforcement action. Please notify myself at margo.kampf@health.ny.gov as soon as the cited violations are corrected, thank you. |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
10/24/2014 | Inspection | All hot & cold food temperatures measured with a metal stem probe thermocouple food probe thermometer were acceptable at 140 degrees F or above and 45 degrees F or below respectively. A thermocouple thermometer is highly recommended for this size operation and the volume & variety of foods. |
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
12/05/2013 | Inspection | Must correct all violations no later than December 19, 2013, except floor must be smoothed and sealed by February 28, 2014. Must send email to Corey DiLorenzo to crd05@health.state.ny.us addressing corrective actions taken to all cited violations no later than 12/19/13. |
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Enough refrigerated storage equipment is not present, properly designed, maintained or operated so that all potentially hazardous foods are cooled properly and stored below 45oF as required.
- Miscellaneous, Economic Violation, Choking Poster, Training.
|
12/11/2012 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
12/14/2011 | Inspection | |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Critical: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Handwashing facilities inaccessible, improperly located, dirty, in disrepair, improper fixtures, soap, and single service towels or hand drying devices missing
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Non food contact surfaces of equipment not clean
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
|
12/09/2010 | Inspection | |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
12/31/2009 | Inspection | |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
|
11/06/2008 | Inspection | |
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Garbage storage areas not properly constructed or maintained, creating a nuisance
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
|
10/25/2007 | Inspection | |
- Pesticide application not supervised by a certified applicator
- Non food contact surfaces of equipment not clean
- Toilet facilities inadequate, inconvenient, dirty, in disrepair, toilet paper missing, not self-closing doors, missing hand wash signs
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
|
11/07/2006 | Inspection | |
| No violation noted during this evaluation. | 10/21/2005 | Inspection | |
Restaurant representatives - add corrected or new information about Wishing Well Restaurant, 745 Saratoga Road, Wilton, NY 12831 »