- Non food contact surfaces of equipment not clean
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
12/23/2015 | Inspection | Please paint the small section of the wall that was repaired in the kitchen. The walls and ceiling in the room where the ice machine is located have been painted. Black Hawk brand 4' X 6' rubber mats have been installed in the walk-in cooler. Discussed cooling, provided a cooling log and asked the owner to complete the log at least once a month for a food item that is cooled for later use. Food temperatures measured: sliced tomatoes = 42 F, steak = 40 F, roasted peppers = 36 F, clam chowder = 172 F. The ANSUL Fire suppression system has not been inspected since 2013. |
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Non food contact surfaces of equipment not clean
- Insects, rodents present
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- In use food dispensing utensils improperly stored
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
|
08/19/2015 | Inspection | Thermometers were calibrated the digital thermometer battery was dead you must have it replaced, the dishwasher was not turned on to test at the time of inspection and test strips were on site. |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
10/10/2014 | Inspection | Mail report to 321 Baldwin rd. A contract with a pest management company has been retained with no evidence of pests evident at the time of inspection. The contract must be submitted to our office for our records. All items an due dates listed on the signed stipulation agreement were reviewed with the items discussed as not being completed noted in the inspection report as such. Please complete by the listed due dates within the report with proof submitted to our office. Two full time food service workers, one from each shift, must complete a food sanitation and safety course, such as serve safe, with proof sent to our office. The class must be completed by December 1, 2014. |
- Pesticide application not supervised by a certified applicator
- In use food dispensing utensils improperly stored
- Non food contact surfaces of equipment not clean
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Non-food contact surfaces and equipment are improperly designed, constructed, installed, maintained (equipment not readily accessible for cleaning, surface not smooth finish)
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Critical: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Insects, rodents present
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Critical: Potentially hazardous foods are not kept at or below 45oF during cold holding, except smoked fish not kept at or below 38oF during cold holding.
|
04/23/2014 | Inspection | Reviewed menu and discussed cooking temperatures. Reviewed cooling, discussed food items for which a cooling log must be completed. Reviewed cooling of cooked pasta ( do not cover until cold, 45 F or below). Provided cooling log. Temperatures measured: Soup = 192 F, baked potato in walk-in = 34.2 F . |
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Non food contact surfaces of equipment not clean
|
10/31/2013 | Inspection | Sent info on CPR station to operator. |
| No violation noted during this evaluation. | 04/11/2013 | Inspection | Operator completed Servsafe. two employee |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Improper thawing procedures used
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Miscellaneous, Economic Violation, Choking Poster, Training.
|
12/21/2012 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Critical: Accurate thermometers not available or used to evaluate potentially hazardous food temperatures during cooking, cooling, reheating and holding.
|
05/11/2012 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
06/06/2011 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
09/16/2010 | Inspection | |
| No violation noted during this evaluation. | 07/22/2009 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
|
10/15/2008 | Inspection | |
- Floors, walls, ceilings, not smooth, properly constructed, in disrepair, dirty surfaces
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Critical: Cooked or prepared foods are subject to cross-contamination from raw foods.
|
08/30/2007 | Inspection | |
| No violation noted during this evaluation. | 09/13/2006 | Inspection | |
Restaurant representatives - add corrected or new information about Ye Olde Fort View Inn, 325 Nys Rte 22, Ticonderoga, NY 12883 »