- Critical: Manual and Mechanical Warewash
- Comment:
- Observed at time of inspection dishwasher is providing 50-100 ppm chlorine sanitizer solution. Corrected.
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
11/21/2014 | Follow-up |
- Critical: Manual and Mechanical Warewash
- Comment:
- Observed at time of inspection dishwasher was providing less then 50 ppm chlorine sanitizer solution. Chlorine solution was switched at time of inspection but machine was still not registering 50-100 ppm chlorine sanitizer solution. Observed a leak coming out of check valve on chlorine sanitizer line this may be preventing the machine from receiving sanitizer at the correct concentration. Correct by repair/replacing dishwasher so it is providing 50-100 ppm chlorine sanitizer solution. This is the second follow up an office consultation may occur. There is a $200 administration fee associated with the office consultation and additional fees if additional follow ups. You will be notified if an office consultation will occur.,
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
11/11/2014 | Follow-up |
- Critical: Manual and Mechanical Warewash
- Comment:
- Observed at time of inspection dishwasher is not providing chemical between 50-100 ppm. At time of follow up maintenance had dish machine pulled apart and are waiting on a part to fix the machine. A follow up will occur in about 10 days. if the violation is not corrected then an office consultation will occur. There is a $200 administration fee associated with the office consultation., ,
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
10/01/2014 | Follow-up |
- Critical: Manual and Mechanical Warewash
- Items:
- Chlorine solution concentration
- Problems:
- Below 25 ppm
- Corrections:
- Provide correct concentration as stated above.
- Comment:
- Observed at time of inspection dishwasher providing less then 50 ppm chlorine sanitizer solution. Correct by repair/replacing machine so that it is providing 50 to 100 ppm chlorine sanitizer solution. Correct immediately. This is a repeat violation fill out provided risk control plan and submit to David Pearson at the Wayne County Health Department within 7 days. A follow up will occur in about 10 days.,
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
- Floors, Walls, and Ceilings
- Items:
- Floor(s)
- Problems:
- Not constructed, designed, installed according to law
- Corrections:
- Remove and replace to be in compliance with law.
- Comment:
- Observed at time of inspection floor in kitchen is missing tiles and has exposed concrete. Correct by replacing floor tiles over bare concrete so that floor is smooth and easily cleanable. Correct as soon as possible a follow up will occur at the next routine inspection.
- General violation description:
- 6-201.11 - Except as specified under # 6-201.14 and except for antislip floor coverings or applications that may be used for safety reasons, floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed, and installed so they are SMOOTH and EASILY CLEANABLE.
|
09/08/2014 | Routine |
- Critical: Manual and Mechanical Warewash
- Comment:
- DISPENSING 50-100PPM
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
10/21/2013 | Follow-up |
| No violation noted during this evaluation. | 10/04/2013 | Follow-up |
- Critical: Equipment, Food-Contact Surfac
- Items:
- Food-contact surface(s)
- Problems:
- With accumulation of debris
- Corrections:
- Keep clean.
- General violation description:
- 4-601.11 - (A) EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be clean to sight and touch. (B) The FOOD-CONTACT SURFACES of cooking EQUIPMENT and pans shall be kept free of encrusted grease deposits and other soil accumulations. N (C) NonFOOD-CONTACT SURFACES of EQUIPMENT shall be kept free of an accumulation of dust, dirt, FOOD residue, and other debris. N
- Critical: Manual and Mechanical Warewash
- Items:
- Chlorine solution concentration
- Problems:
- Below 25 ppm
- Corrections:
- Provide correct concentration as stated above.
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
08/29/2013 | Routine |
| No violation noted during this evaluation. | 08/17/2012 | Routine |
| No violation noted during this evaluation. | 08/30/2011 | Routine Inspection |
- Critical: Warewashing Chem.San., Temp/pH
- Comment:
- CHLORINE AT 50 PPM DURING RINSE CYCLE. VIOLATION CORRECTED.
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
09/15/2010 | Follow-up |
- Critical: Warewashing Chem.San., Temp/pH
- Items:
- Chlorine solution concentration
- Problems:
- Below 50 ppm
- Corrections:
- Provide correct concentration as stated above.
- Comment:
- CHLORINE CONCENTRATION BELOW 50 PPM DURING RINSE CYCLE, SUPPLY LINE HAS DISCONNECTED FROM MACHINE. CHLORINE MUST BE 50-100 PPM TO EFFECTIVELY SANITIZE. WILL RETURN ON/ABOUT 9-3-10 TO VERIFY COMPLIANCE.
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
- Critical: Warewashing Chem.San., Temp/pH
- Items:
- Chlorine solution concentration
- Problems:
- Below 50 ppm
- Corrections:
- Provide correct concentration as stated above.
- Comment:
- CHLORINE CONCENTRATION BELOW 50 PPM DURING RINSE CYCLE, SUPPLY LINE HAS DISCONNECTED FROM MACHINE. CHLORINE MUST BE 50-100 PPM TO EFFECTIVELY SANITIZE. WILL RETURN ON/ABOUT 9-3-10 TO VERIFY COMPLIANCE.,
- General violation description:
- 4-501.114 - A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under 4-703.11(C) shall be listed in 21 CFR 178.1010 Sanitizing solutions, shall be used in accordance with the EPA-approved manufacturer's label use instructions, and shall be used as follows: (A) A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart
|
08/23/2010 | Routine Inspection |
| No violation noted during this evaluation. | 08/20/2009 | Routine Inspection |
- Repairing
- Items:
- Physical facilities Wall(s)
- Problems:
- In poor repair
- Corrections:
- Repair/replace.
- Comment:
- SOME PEELING PAINT ABOVE 2-COMPARTMENT SINK. WALLS MUST BE SMOOTH AND EASILY CLEANABLE. PAINT WALL.
- General violation description:
- 6-501.11 - PHYSICAL FACILITIES shall be maintained in good repair.
|
02/12/2009 | Routine Inspection |
| No violation noted during this evaluation. | 08/06/2008 | Routine Inspection |
Restaurant representatives - add corrected or new information about Grosse Pointe Baptist Church, 21336 Mack Ave, Grosse Pointe Woods, MI 48236 »