- Cleaning of Plumbing Fixtures
- Items:
- Handwashing facility
- Locations:
- Facility
- Problems:
- Soiled
- Corrections:
- Keep clean.
- Comment:
- OBSERVED ALL HANDWASHING SINKS TO BE SOILED
- General violation description:
- 6-501.18 - PLUMBING FIXTURES such as HANDWASHING SINKS, toilets, and urinals shall be cleaned as often as necessary to keep them clean.
- Toilet Rooms, Enclosed
- Items:
- Toilet room(s)
- Locations:
- Facility
- Problems:
- Not provided with Self-closing door
- Corrections:
- Provide self-closing door.
- General violation description:
- 6-202.14 - Except where a toilet room is located outside a FOOD ESTABLISHMENT and does not open directly into the FOOD ESTABLISHMENT such as a toilet room that is provided by the management of a shopping mall, a toilet room located on the PREMISES shall be completely enclosed and provided with a tight-fitting and self-closing door.
|
03/06/2015 | Routine |
- Critical: Potentially Hazardous Food (Ti
- Comment:
- Observed at time of inspection food in reach in at 41 F. Corrected.
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
|
10/08/2014 | Follow-up |
- Critical: Potentially Hazardous Food (Ti
- Items:
- Cold food item(s)
- Problems:
- Stored above 41 degrees f
- Corrections:
- Store below 41 degrees F.
- Comment:
- ,
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
- Outer Openings, Protected
- Items:
- Outer opening(s)
- Problems:
- Not tight-fitting
- Corrections:
- Repair/replace to meet requirements above.
- General violation description:
- 6-202.15 - (A) Except as specified in ## (B), (C), and (E) and under # (D) of this section, outer openings of a FOOD ESTABLISHMENT shall be protected against the entry of insects and rodents by: (1) Filling or closing holes and other gaps along floors, walls, and ceilings
|
09/23/2014 | Routine |
- Good Repair and Proper Adjustm
- Items:
- Equipment
- Problems:
- In poor repair
- Corrections:
- Repair/replace.
- Comment:
- Observed one drain stopper working at three compartment sink correct by providing a working stopper for each compartment. Correct as soon as possible a follow up will occur at the next routine inspection.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Prohibition
- Items:
- Jewelry
- Problems:
- Worn on hands/arms during prep
- Corrections:
- Remove during periods of food handling and preparation
- Comment:
- Observed employee wearing bracelets on wrist correct by removing bracelets during food prep. Corrected at time of inspection bracelets removed. Corrected.
- General violation description:
- 2-303.11 - Except for a plain ring such as a wedding band, while preparing FOOD, FOOD EMPLOYEES may not wear jewelry including medical information jewelry on their arms and hands.
|
03/26/2014 | Routine |
| No violation noted during this evaluation. | 10/29/2013 | Follow-up |
- Critical: Temperature Measuring Devices
- Items:
- Thermometer(s)
- Problems:
- Not provided
- Corrections:
- Provide.
- General violation description:
- 4-204.112 - (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Except as specified in # (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURNG DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars. (D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1°C or 2°F in the intended range of use.(Pf)
|
09/11/2013 | Routine |
- Critical: Demonstration of Knowledge
- Items:
- Person-in-charge
- Problems:
- Does not demonstrate required knowledge
- Corrections:
- Knowledge is to be obtained through an approved training program.
- Comment:
- THE EMPLOYEES PRESENT AT THE TIME OF INSPECTION ARE NOT KNOWLEDGEABLE ON THE FOLLOWING FOOD SAFETY ITEMS: -PROPER SET-UP OF THE 3-COMPARTMENT SINK FOR WARE WASHING -ILLNESSES AND SYMPTOMS THAT REQUIRE REPORTING TO THE PERSON IN CHARGE AN EMPLOYEE WHO IS KNOWLEDGEABLE ON PERTINENT FOOD SAFETY ITEMS MUST BE PRESENT AT ALL TIMES WHEN THE FACILITY IS IN OPERATION. TRAIN STAFF AS REQUIRED. CORRECTED AT TIME OF INSPECTION. THE OWNER ARRIVED AND FOOD SAFETY WAS DISCUSSED WITH THE STAFF. THE OWNER WILL COMPLETE THE REQUIRED STANDARD OPERATING PROCEDURES.
- General violation description:
- 2-102.11 - Based on the risks of foodborne illness inherent to the FOOD operation, during inspections and upon request the PERSON IN CHARGE shall demonstrate to the REGULATORY AUTHORITY knowledge of foodborne disease prevention, application of the HAZARD Analysis CRITICAL CONTROL POINT principles, and the requirements of this Code. The PERSON IN CHARGE shall demonstrate this knowledge by compliance with this Code, by being a certified FOOD protection manager who has shown proficiency of required information through passing a test that is part of an ACREDITED PROGRAM, or by responding correctly to the inspector's questions as they relate to the specific FOOD operation. The areas of knowledge include: (A) Describing the relationship between the prevention of foodborne disease and the personal hygiene of a FOOD EMPLOYEE
- Closing Toilet Room Doors
- Items:
- Door
- Problems:
- Propped open
- Corrections:
- Do not prop door open.
- Comment:
- KEEP EMPLOYEE RESTROOM DOORS CLOSED EXCEPT DURING CLEANING.
- General violation description:
- 6-501.19 - Except during cleaning and maintenance operations, toilet room doors as specified under # 6-202.14 shall be kept closed.
|
09/17/2012 | Routine |
Restaurant representatives - add corrected or new information about Uncle Paul's Pizza, 21215 Mack, Grosse Pointe Woods, MI 48236 »