- Critical: Potentially Hazardous Food (Ti
- Comment:
- Corrected by repairing cooler and holding food at 41F.
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
|
09/18/2014 | Follow-up |
- Critical: Potentially Hazardous Food (Ti
- Items:
- Cold food item(s)
- Locations:
- make table
- Problems:
- Stored above 41 degrees f
- Corrections:
- Store below 41 degrees F.
- Comment:
- In the left pizza cooler: pizza cheese is 49f, ham and pepperoni 45f. Hold at or below 41f. Correct immediately. Do not use cooler past today unless it can hold food at or below 41f. This is a repeat violation: complete the risk control plan and fax to number on form within 2 days.,
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
- Critical: Using a Handwashing Sink
- Items:
- Handwashing sink(s)
- Locations:
- food prep area
- Problems:
- Not easily accessible Items stored In
- Corrections:
- Remove items from handsink. Do not store items at handsink.
- Comment:
- Hand held mixer stored in hand sink: do not store in hand sink. Keep sink accessible for hand cleaning only. Corrected by removing from sink.
- General violation description:
- 5-205.11 - (A) A HANDWASHING SINK shall be maintained so that it is accessible at all times for EMPLOYEE use. (Pf) (B) A HANDWASHING SINK may not be used for purposes other than handwashing. (Pf) (C) An automatic handwashing facility shall be used in accordance with manufacturer's instructions. (Pf)
- Toilet Rooms, Enclosed
- Items:
- Toilet room(s)
- Locations:
- employee restroom
- Problems:
- Not provided with Self-closing door
- Corrections:
- Provide self-closing door.
- Comment:
- Provide a closer on the rest room door and keep closed.
- General violation description:
- 6-202.14 - Except where a toilet room is located outside a FOOD ESTABLISHMENT and does not open directly into the FOOD ESTABLISHMENT such as a toilet room that is provided by the management of a shopping mall, a toilet room located on the PREMISES shall be completely enclosed and provided with a tight-fitting and self-closing door.
|
08/13/2014 | Routine |
- Critical: Potentially Hazardous Food (Ti
- Items:
- Cold food item(s)
- Problems:
- Stored above 41 degrees f
- Corrections:
- Store below 41 degrees F.
- Comment:
- OBSERVED HAM AND PEPPERONI IN PIZZA COOLER (LEFT) TOP AT 47F. HOLD AT OR BELOW 41F., CORRECTED BY USING TIME MARKING FOR 4 OR LESS HOURS AND SMALL BATCHES WITH CONTAINERS CHANGED AFTER/WITH EACH BATCH. PARTS TO REPAIR COOLER ON ORDER.
- General violation description:
- 3-501.16 - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under 3-501.19, POTENTIALLY HAZARDOUS FOOD shall be maintained: (A) At 60C (140F) or above, except that roasts cooked to a temperature and for a time specified under 3-401.11(B) or reheated as specified in 3-403.11(E) may be held at a temperature of 54C (1300F)
|
08/16/2013 | Routine |
| No violation noted during this evaluation. | 02/14/2013 | Routine |
- Outside receptacles
- Items:
- Waste receptacle(s)
- Problems:
- With doors,lids or covers Left open
- Corrections:
- Keep closed.
- General violation description:
- 5-501.15 - (A) Receptacles and waste handling units for REFUSE, recyclables, and returnables used with materials containing FOOD residue and used outside the FOOD ESTABLISHMENT shall be designed and constructed to have tight-fitting lids, doors, or covers. (B) Receptacles and waste handling units for REFUSE and recyclables such as an on-site compactor shall be installed so that accumulation of debris and insect and rodent attraction and harborage are minimized and effective cleaning is facilitated around and, if the unit is not installed flush with the base pad, under the unit.
|
08/03/2012 | Routine |
| No violation noted during this evaluation. | 01/10/2012 | Routine Inspection |
| No violation noted during this evaluation. | 07/12/2011 | Routine Inspection |
| No violation noted during this evaluation. | 01/12/2011 | Routine Inspection |
- Good Repair and Proper Adjustm
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Good Repair and Proper Adjustm
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
|
07/13/2010 | Routine Inspection |
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- Comment:
- Fix the hand wash station located in the dish room.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- Comment:
- Fix the hand wash station located in the dish room.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- Comment:
- Fix the hand wash station located in the dish room.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- Comment:
- Fix the hand wash station located in the dish room.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Good Repair and Proper Adjustm
- Items:
- Equipment
- Problems:
- Broken
- Corrections:
- Repair/replace.
- Comment:
- Fix the hand wash station located in the dish room.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
|
05/13/2010 | Routine Inspection |
Restaurant representatives - add corrected or new information about Jets Pizza, 28398 Telegraph, Flat Rock, MI 48134 »