| No violation noted during this evaluation. | 09/09/2015 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- In use food dispensing utensils improperly stored
- Tobacco is used; eating, drinking in food preparation, dishwashing food storage areas
|
08/15/2014 | Inspection | |
- Miscellaneous, Economic Violation, Choking Poster, Training.
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
|
07/26/2013 | Inspection | |
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- In use food dispensing utensils improperly stored
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
09/27/2012 | Inspection | |
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
- Critical: Potentially hazardous foods are not cooled by an approved method where the food temperature can be reduced from 120oF to 70oF or less within two hours and 70oF to 45oF within four hours.
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
|
05/20/2010 | Inspection | Provided and reviewed with operator ill food worker policy, TCS and Safe handling fact sheets, proper cooling of PH foods & general food safeness temperatures. Chlorine DPD Hach free sampled at upstair men's restroom hand wash sink fixture @ approximately 0.5 ppm detected. Also tobacco products should not be kept above a food perp table-operator instructed staff person to remove from this area. |
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Critical: Toxic chemicals are improperly labeled, stored or used so that contamination of food can occur.
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Insects, rodents present
- Accurate thermometers not available or used to evaluate refrigerated or heated storage temperatures
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food contact surfaces not washed, rinsed and sanitized after each use and following any time of operations when contamination may have occurred
- Non food contact surfaces of equipment not clean
|
07/08/2008 | Inspection | |
- Food not protected during storage, preparation, display, transportation and service, from potential sources of contamination (e.g., food uncovered, mislabeled, stored on floor, missing or inadequate sneeze guards, food containers double stacked)
- Single service items reused, improperly stored, dispensed, not used when required
- Tobacco is used; eating, drinking in food preparation, dishwashing food storage areas
- Effective measures not used to control entrance (rodent-, insect-proof contruction). Harborage areas available for rodents, insects and other vermin
- Lighting and ventilation inadequate, fixtures not shielded, dirty ventilation hoods, ductwork, filters, exhaust fans
- Plumbing and sinks not properly sized, installed, maintained; equipment and floors not properly drained
- Manual facilities inadequate, technique incorrect; mechanical facilities not operated in accordance with manufacturer's instructions
- Food (ice) contact surfaces are improperly designed, constructed, installed, located (cracks, open seams, pitted surfaces, tin cans reused, uncleanable or corroded food contact surfaces)
|
07/20/2007 | Inspection | |
Restaurant representatives - add corrected or new information about West Branch Angler & Sportsman, 150 Faulkner Road, Deposit, NY 13754 »